2000 FORD F-250
200 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I'm trying to replace my flexplate. ive undone evrything i can see, have a tranniejack under it but i cant get it to seperate from the motor. i pulled six bolts from the bell housing. is there another bolt i missed or does it need to be in neutral to seperate it from the motor?
Oct 20, 2012 at 6:21 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
spray some penetrating fluid around crank and let sit for a couple of hours. then try to remove, if still stuck take a hammer and hit aroundend of crank and see if it breaks loose, it normally does.
Oct 20, 2012 at 7:12 PM
Advertisement