best way to reinstall alternator
Apr 10, 2013 at 5:57 PM
1999 ISUZU AMIGO
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
since you provided no engine size i assume it is a 4 cylinder 4 wheel drive
Roy
1.Disconnect battery ground cable.
2.Move drive belt tensioner to loose side using wrench then remove drive belt.
3.Disconnect terminal B wiring connector and connector.
4.Remove generator bracket (1), (2) and remove generator assembly.
Installation
1.Install generator assembly and bring generator assembly to the position to be installed.
2.Install generator bracket (1), (2) and tighten to the specified torque. Torque:
Long bolt: 35 Nm (26 lb.ft)
Short bolt:20 Nm (15 lb.ft)
3.Connect wiring harness connector.
4.Move drive belt tensioner to loose side using wrench, then install drive belt to normal position.
5.Reconnect battery ground cable.
Roy
1.Disconnect battery ground cable.
2.Move drive belt tensioner to loose side using wrench then remove drive belt.
3.Disconnect terminal B wiring connector and connector.
4.Remove generator bracket (1), (2) and remove generator assembly.
Installation
1.Install generator assembly and bring generator assembly to the position to be installed.
2.Install generator bracket (1), (2) and tighten to the specified torque. Torque:
Long bolt: 35 Nm (26 lb.ft)
Short bolt:20 Nm (15 lb.ft)
3.Connect wiring harness connector.
4.Move drive belt tensioner to loose side using wrench, then install drive belt to normal position.
5.Reconnect battery ground cable.
Apr 13, 2013 at 6:25 AM
Advertisement