Will not start on its own but will with ether

Tiny
ELIZABETH1212
  • MEMBER
  • 1999 FORD RANGER
  • 99,000 MILES
Does anyone have any suggestions 99 ford ranger will not start on its own you can spray it with ether it will start and run until you shut it off it just has a little bit of high idle and will not switch gears unless you do it manually and then you can still only get 1st and 2nd. The dealer says there is a short. Where would you start looking at for a short
Monday, September 24th, 2012 AT 8:01 PM

6 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Does it have any codes in the system?

What is the fuel pressure?

Roy
Was this
answer
helpful?
Yes
No
Monday, September 24th, 2012 AT 8:43 PM
Tiny
ELIZABETH1212
  • MEMBER
  • 10 POSTS
Fuel pressure is 55 and no codes
Was this
answer
helpful?
Yes
No
-1
Monday, September 24th, 2012 AT 9:03 PM
Tiny
ELIZABETH1212
  • MEMBER
  • 10 POSTS
Also the dealer said there's a short because when he would plug scanner tool to truck it would say turn on key and he said the key was on
Was this
answer
helpful?
Yes
No
-1
Monday, September 24th, 2012 AT 9:11 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Start with power and grounds to the ecm.

Roy
Was this
answer
helpful?
Yes
No
Tuesday, September 25th, 2012 AT 1:31 AM
Tiny
ELIZABETH1212
  • MEMBER
  • 10 POSTS
Checked resistance and voltage it's good
Was this
answer
helpful?
Yes
No
Tuesday, September 25th, 2012 AT 1:36 AM
Tiny
ELIZABETH1212
  • MEMBER
  • 10 POSTS
Can you tell me what the DLC pins should measure voltage and ground wise?
Was this
answer
helpful?
Yes
No
+1
Tuesday, September 25th, 2012 AT 1:26 PM

Please login or register to post a reply.

Sponsored links