Car is posessed, alarm stopping me for driving

1999 CHRYSLER CIRRUS
30,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
ABBEYISHERE
  • MEMBER
  • 1 POST
My car had a starter remote, and the techs said it was a bad module so they disconnected the alarm and the remote starter. So now when I open the door, shut the door, or even try and start the car, the alarm goes of not letting me start the car. IDK what else to do, and they don't know whats going on because they said the alarm is disabled...but it isn't. HELP!
Dec 25, 2010 at 10:04 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
sounds like they only disconnected the module and not the alarm. if they disconnected the skim module then the pcm has to be reprogrammed to let it knowwhat's been done. Of course this is assuming ththis is a factory unit.
Feb 4, 2011 at 7:30 PM
Advertisement