Charging System Problems

Tiny
RICHARD FERRAN
  • MEMBER
  • 2 POSTS
Yes the battery light does com on and after it is running it stays on
Was this
answer
helpful?
Yes
No
-1
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
CARADIODOC
  • MECHANIC
  • 33,916 POSTS
Just to be sure that wire isn't grounded someplace, unplug the connector and verify the light goes out.

Did you check for voltage on the large wire on the generator?

Caradiodoc
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
NODNARBROX
  • MEMBER
  • 4 POSTS
  • 1995 CHEVROLET CAVALIER
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 220,000 MILES
Check fuse blocks, fuses, wire to fuse block. Battery wire, Fusible link good continuity from solenoid to alternator, Alternator and Battery tested good bought new ones in case. Alternator connections good. Battery connections are solid. Starter wires good even ground. Made extra grounds just in case. There are 3 little wires on alternator. There is a brown wire I hooked 12v to it Battery light goes off its charging. Does this wire go to the PCM. If so could my PCM be malfunctioning because I changed the coil pack it was off a diff model gm. It looked the same. It fit in there fine. But is my PCM freaking out because of it
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
84CAVALIER
  • MEMBER
  • 2 POSTS
I am having the same problem from a 84 cavalier three alts and two batteries later and its just sitting out there dead all my wires and grounds r goo its like the battery only charges sometimes. Please let me know what u figure out this is so frustrating
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
WITTENOFF
  • MEMBER
  • 1 POST
  • 1993 CHEVROLET CAVALIER
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 125,000 MILES
I have a 1993 chev cavalier. It has a new battery (reads 12.65 volts) and bench tested altenator (good). The battery is not charging. Noticed the battery warning light does not come on when the ignition is turned on or come on when engine is running. I was informed that the light is hooked up in series with the altenator and if it is burned out it won't send a signal to altenator to charge battery. How do I remove/replace the bulb?
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
No light does not provide field. When Alt starts charging it removes ground form light turning off. Field is powered from HTR-AC so chek that first
Need to remove gague panel to replace light
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Remove the panel cluster. See what's what.

Disconnect negative battery cable. Remove 4 steering column opening filler screws. Remove steering column opening filler. Pull down on steering column and remove 2 screws from bottom of cluster extention. Remove connector from instrument panel dimmer and interior light control switches. Remove 2 screws from top of cluster. Pull cluster rearward to remove. Installation is the reverse of removal.
Was this
answer
helpful?
Yes
No
Thursday, December 19th, 2019 AT 1:41 PM (Merged)

Please login or register to post a reply.

Sponsored links