EVAP purge control solenoid

Tiny
ALEXNGUYEN
  • MEMBER
  • 1998 HONDA ACCORD
  • 150 MILES
Hi, I bought this 98 accord v6 few years back, and I just found out that it was running without the evap purge control solenoid. The 2 pin connector is empty, nothing connect to it, so the previous owner must bypass it somehow, it was running fine, lately I find that the car sometime feels like the engine doesnt get enough gas, I have to floor the gas pedal few times before it idle normally, and smell gas sometime. My question is can I install that evap connector cable, if I buy one, what do I have to do in order to install it, or just run without it.
Thanks for your help
Alex
Monday, April 9th, 2012 AT 9:39 PM

3 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
If you have been running for this long it shouldn't hurt it, but you would need a new evap canniste solenoid as you sya you have hte connector. But check your fuel pressure it may be low.
Was this
answer
helpful?
Yes
No
Monday, April 9th, 2012 AT 10:29 PM
Tiny
FIXITMR
  • MECHANIC
  • 9,990 POSTS
Not likely a problem since has been running so long without it.
Was this
answer
helpful?
Yes
No
Monday, April 9th, 2012 AT 10:45 PM
Tiny
DJCL
  • MECHANIC
  • 767 POSTS
Is the engine light on? It should be with a missing purge valve. I would want to check the computer for trouble codes. I would also recommend checking the timing belt to see if it's off
Was this
answer
helpful?
Yes
No
Monday, April 9th, 2012 AT 11:31 PM

Please login or register to post a reply.

Sponsored links