1998 Chrysler Concorde Intermittent jerking during deceleration

Tiny
BRANDON324
  • MEMBER
  • 1998 CHRYSLER CONCORDE
  • 72,000 MILES
During car start up the car seems to idle rough but still idling just below 1000RPM, during acceleration there is sometimes a delay in responsiveness, but once the car has taken off and I am accelerating it seems to react normally, however during deceleration there is some fairly violent jerking. This is an intermittent problem and won't happen for weeks at a time and then it will occur again. Error code reads P1297. I recently replaced the MAP sensor, Camshaft Sensor and Crankshaft sensor to try to fix this problem, I replaced them about three weeks ago and had the problem reoccur so I'm back to the drawing board.
Monday, October 14th, 2013 AT 7:55 AM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check for a vacuum leak first use choke cleaner to spray around. Then check for a restricted hose or soft hose going to map then wiggle test wires near map an dpcm where ever engine stalls then fix the harness/connectors. Other than that have apro look at it.
Was this
answer
helpful?
Yes
No
Monday, October 14th, 2013 AT 9:29 AM

Please login or register to post a reply.

Sponsored links