new head gasket, timing is all good

1997 NISSAN TRUCK
120,109 MILES
Avatar
CRIS
  • MEMBER
  • 3 POSTS
1997 nissan 4x4 4 cylinder idling is ok, no dtc. Engine cut out at full open throttle,at about 3500 rpm then comes back when rpm goes down. Anyone know?
Dec 24, 2011 at 5:13 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Have it scanned for live data and let us know what is returned.
Dec 24, 2011 at 6:21 AM
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
Have you actually scanned for codes as not all codes will set a check light, check fuel pressure as well, start here.
Dec 24, 2011 at 6:22 AM
Avatar
CRIS
  • MEMBER
  • 3 POSTS
no codes
Dec 24, 2011 at 6:36 AM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Both hard and soft codes? Soft codes don't set the CEL. What about live data? The live data stream will give us the best idea of what is going on when this problem occurs.
Dec 24, 2011 at 7:15 AM
Avatar
CRIS
  • MEMBER
  • 3 POSTS
30 psi idling but drops at full open throtle
Dec 26, 2011 at 6:16 AM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
Live computer data.
Dec 26, 2011 at 6:24 AM
Avatar
CRISJOHN
  • MEMBER
  • 9 POSTS
scaned with a code reader P0110 came up sorry can't get live data.
Feb 20, 2012 at 12:28 PM
Avatar
RIVERMIKERAT
  • CAR REPAIR CONTRIBUTOR
  • 6,110 POSTS
P0110 is the intake air temperature sensor circuit.
Minimum acceptable fuel pump pressure is 34 PSI at idle. Recommended is around 40 PSI. It sounds like your fuel pump is quite weak.
Feb 20, 2012 at 8:58 PM