How do I reprogram my factory installed remote.

Tiny
ANONYMOUS
  • MEMBER
  • 1997 CHRYSLER LHS
  • 15,000 MILES
How do I reprogram my factory installed remote after changing the batteries?
Sunday, March 31st, 2013 AT 6:11 AM

1 Reply

Tiny
CARADIODOC
  • MECHANIC
  • 33,916 POSTS
The Remote Keyless Entry (RKE) module is programmed with the Chrysler DRB3 scanner to the remotes. The remotes only produce the one signal they're built with and do not get reprogrammed. They still produce the same signal when the battery is replaced. Be sure the battery isn't installed upside-down and there's no fingerprint grease on either side.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, March 31st, 2013 AT 6:21 AM

Please login or register to post a reply.

Related Battery Replace/Remove Content

Battery Replacement
VIDEO
Battery Replacement
Instructional repair video
Battery Replacement
GUIDE
Battery Replacement
Replacing a car battery is easy to do and will take about 20 minutes in most cases, this job can be done using everyday tools. Please wear protective gloves and eyewear when...
VIEW MORE

Sponsored links