Friday, February 10th, 2012 AT 7:47 PM
SONNYSGAL69
- MEMBER
- 1997 CHEVROLET LUMINA
Trying to program a new remote
SPONSORED LINKS
Where is the rke programming wire in a 1997chevy Lumina
6 Replies
SONNYSGAL69
- MEMBER
- 9 POSTS
What can I use to ground the rke programming wire
SPONSORED LINKS
Was this helpful?
Yes
No
Friday, February 10th, 2012 AT 9:30 PM
WRENCHTECH
- MECHANIC
- 20,761 POSTS
A jumper wire with alligator clips as shown.
Was this helpful?
Yes
No
+1
Friday, February 10th, 2012 AT 9:31 PM
SONNYSGAL69
- MEMBER
- 9 POSTS
If I donthave a jumper wire with alligator clips where do I get them from
Was this helpful?
Yes
No
-1
Friday, February 10th, 2012 AT 9:36 PM
WRENCHTECH
- MECHANIC
- 20,761 POSTS
Radio Shack or auto parts store.
Was this helpful?
Yes
No
-1
Friday, February 10th, 2012 AT 9:38 PM
SONNYSGAL69
- MEMBER
- 9 POSTS
Could I get the instructions for programming a car key pad on a 1997 chevy lumina through the rke programming connector wire
SPONSORED LINKS
Was this helpful?
Yes
No
-2
Friday, February 10th, 2012 AT 9:42 PM
WRENCHTECH
- MECHANIC
- 20,761 POSTS
I thought you already had that.
REMOVE OR DISCONNECT
Open the rear compartment lid.
Right side rear compartment trim for access.
Using a jumper wire with alligator clips, ground the transmitter program wire terminal. The door locks will lock and unlock, indicating that the receiver is in the program mode.
With the system still grounded, program all of the transmitters.
Chevrolet press and hold the "LOCK" and "UNLOCK" buttons simultaneously for 10 seconds.
Oldsmobile press and hold any button on the transmitter.
The door locks will lock and unlock, indicating that the transmitter has been programmed
Repeat step 4 for each transmitter to be programmed.
Remove jumper wire from the transmitter program wire terminal.
Verify operation of the transmitter(s).
INSTALL OR CONNECT
Right side rear compartment trim.
Close the rear compartment lid.
REMOVE OR DISCONNECT
Open the rear compartment lid.
Right side rear compartment trim for access.
Using a jumper wire with alligator clips, ground the transmitter program wire terminal. The door locks will lock and unlock, indicating that the receiver is in the program mode.
With the system still grounded, program all of the transmitters.
Chevrolet press and hold the "LOCK" and "UNLOCK" buttons simultaneously for 10 seconds.
Oldsmobile press and hold any button on the transmitter.
The door locks will lock and unlock, indicating that the transmitter has been programmed
Repeat step 4 for each transmitter to be programmed.
Remove jumper wire from the transmitter program wire terminal.
Verify operation of the transmitter(s).
INSTALL OR CONNECT
Right side rear compartment trim.
Close the rear compartment lid.
Was this helpful?
Yes
No
-1
Friday, February 10th, 2012 AT 9:46 PM
