Translate
Raise and support front of vehicle. Remove wheels. Using T25 Torx bit, remove locking hub cap assembly screws. Remove cap assembly. Remove lock ring (seated in groove of wheel hub). Remove locking hub assembly from hub and brake rotor assembly. Remove caliper with brake line attached, and wire aside.
Remove snap ring. Noting position of thrust washers, remove 3 thrust washers and cam assembly from end of axle shaft (spindle). See Fig. 1. Remove wheel bearing retainer key. Using Spanner Lock Nut Wrench (T85T-1197-B), remove wheel bearing retainer nut.
Remove hub and brake rotor assembly. Outer bearing will slide off with hub. Remove grease seal and inner bearing. If bearings require replacement, remove races from hub with Internal Puller (T77F-1102-A) and attached slide hammer
Image (Click to make bigger)
SPONSORED LINKS
Sunday, November 17th, 2013 AT 8:22 AM