SPONSORED LINKS

1996 Town and Country, heat problems

Tiny
JBURGMANN
  • MEMBER
  • 1996 CHRYSLER TOWN AND COUNTRY
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 1 MILES
I have a 1996 Town and country with no heat on the drivers side. I ran a calibration test on the front panel and it said there was a problem with the "ZONE/DRIVER ACTUATOR DID NOT REACH HEAT STOPZONE/DRIVER ACTUATOR DID NOT REACH HEAT STOP" I figured the actuator went bad so I got a new one, replaced it and now I get the code "BLEND PASS. ACTUATOR DID NOT REACH HEAT STOP ". Is this more of a mechanical problem with the doors themselves or did I do something wrong when I installed the actuators?
Thanks,
Jon B
SPONSORED LINKS
Monday, November 15th, 2010 AT 4:28 PM

2 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
Jon:
I think the first code was a result of the blend door actuator. If it isn't functioning properly, it will kick the other code. Check the blend door to see if it is sticking or not working at all.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Monday, November 15th, 2010 AT 4:30 PM
Tiny
JBURGMANN
  • MEMBER
  • 3 POSTS
How do I see if it is sticking?
Was this
answer
helpful?
Yes
No
Monday, November 15th, 2010 AT 4:32 PM

Please login or register to post a reply.

Related One Side Content

VIEW MORE

Sponsored links