Car cranks but wont start

Tiny
DELSANGEL
  • MEMBER
  • 1995 FORD TAURUS
  • 164,733 MILES
1995 taurus with 3.0 ohv had it in the shop was told it needed a disturbator replaced it took them 3 remanfuctured ones till it finally started and ran for 1 day and now wont start no spark we have checked all grounds looked at most of the wiring and cant seem to figure there are no ecm codes we can take the dist out and put it back in and it will run for about 45sec then nothing
Monday, April 2nd, 2012 AT 6:53 PM

6 Replies

Tiny
DJCL
  • MECHANIC
  • 767 POSTS
Sounds like a bad connection in the distributor. Check the module to pick up connection. Will it run with the spout disconnected?
Was this
answer
helpful?
Yes
No
Monday, April 2nd, 2012 AT 7:11 PM
Tiny
DELSANGEL
  • MEMBER
  • 4 POSTS
Not sure what spout connection you are talking about as it is. Now no start at all The distributor is a new remand
Was this
answer
helpful?
Yes
No
Monday, April 2nd, 2012 AT 7:20 PM
Tiny
DJCL
  • MECHANIC
  • 767 POSTS
There is a 2 wire plug @ the distributor its a gray plug
Was this
answer
helpful?
Yes
No
-1
Monday, April 2nd, 2012 AT 7:36 PM
Tiny
DELSANGEL
  • MEMBER
  • 4 POSTS
Just pulled it out and yes it started ran for a bit then died
Was this
answer
helpful?
Yes
No
Monday, April 2nd, 2012 AT 7:42 PM
Tiny
DELSANGEL
  • MEMBER
  • 4 POSTS
I got it to restart put that Plug back in it seems to be working now what does that plug do?
Was this
answer
helpful?
Yes
No
Monday, April 2nd, 2012 AT 7:56 PM
Tiny
DJCL
  • MECHANIC
  • 767 POSTS
If it now runs you just eliminated the dist and all its parts. Your looking @ a short in the wire to the pcm or a bad pcm.
Was this
answer
helpful?
Yes
No
-1
Monday, April 2nd, 2012 AT 8:18 PM

Please login or register to post a reply.

Sponsored links