Clutch rod is falling off pivot

Tiny
JMURT031787
  • MEMBER
  • 1995 FORD F-150
I just replaced the clutch master cylinder on my 95 ford f150 and it was running good until the clutch rod popped off inside. Is that known to happen? The clutch pivot arm that pushes the rod into the master cylinder from inside the firewall to the master under the hood. The rod attached to the pivot arm is where it pops off.
Thursday, December 15th, 2011 AT 9:36 PM

3 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Is there clip that holds it in place?
Was this
answer
helpful?
Yes
No
Thursday, December 15th, 2011 AT 9:39 PM
Tiny
JMURT031787
  • MEMBER
  • 1 POST
Yes there is a clip on it
Was this
answer
helpful?
Yes
No
Thursday, December 15th, 2011 AT 10:09 PM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,755 POSTS
Check to make sure the clip is doing its job and is properly installed.
Was this
answer
helpful?
Yes
No
Thursday, December 15th, 2011 AT 10:21 PM

Please login or register to post a reply.

Sponsored links