SPONSORED LINKS

S-10 clutch

Tiny
DENISE BENSON
  • MEMBER
  • 1995 CHEVROLET S-10
  • 4 CYL
  • 2WD
  • MANUAL
Replace clutch pressure plate and throw out bearing for a 1995 s10, will not go into gear, just grinds. Could it be low hydrolic fluid or air in hydrolic?
Friday, February 11th, 2011 AT 7:27 PM

5 Replies

Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Was system bleed?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Friday, February 11th, 2011 AT 7:55 PM
Tiny
DENISE BENSON
  • MEMBER
  • 3 POSTS
Yes
Was this
answer
helpful?
Yes
No
-3
Friday, February 11th, 2011 AT 9:12 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Place a tube over bleedr valve other end in container of fluid. Open bleeder pump pedaltill all air is out
Was this
answer
helpful?
Yes
No
Friday, February 11th, 2011 AT 9:36 PM
Tiny
DENISE BENSON
  • MEMBER
  • 3 POSTS
How to remove slave cylinder?
Was this
answer
helpful?
Yes
No
+1
Saturday, February 12th, 2011 AT 4:56 PM
Tiny
DOCFIXIT
  • MECHANIC
  • 18,828 POSTS
Unbolt off bell housing unit it not servicable master and slave sold as unit
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Sunday, February 13th, 2011 AT 7:44 PM

Please login or register to post a reply.

Related Transmission Clutch Throw Out Bearing Content

Throwout Bearing - Secondary Cylinder Replacement
GUIDE
Throwout Bearing - Secondary Cylinder Replacement
A throwout bearing/secondary cylinder is used to apply force against the clutch pressure plate to release the clutch disc and should be replaced as part of the normal clutch...
VIEW MORE

Sponsored links