replaced control module on 94 nissan pickjup now it cannot get it timed so it has any power
Jun 10, 2012 at 3:52 PM
does control module have to be reset when replaced
1994 NISSAN HARDBODY
TOSHAK
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
no, obd 1 systems come with all the info from the factory when you purchase a new one. it should be a plug and play.
Roy
Roy
Jun 10, 2012 at 4:22 PM
Advertisement
this was a used salvage yard unit do not know what vehicle it came from it plugs right up. and starts truck but very little power.
Jun 10, 2012 at 5:51 PM
most likely will not work. each unit is made for the specific vehicle.
Roy
Roy
Jun 10, 2012 at 6:05 PM
Check the part number on the box. Both should be identical. If P/N are different, it usually does not work correctly.
The problem could be mechanical instead of the ECM.
The problem could be mechanical instead of the ECM.
Jun 10, 2012 at 6:29 PM