Stalls while driving?

Its carburated fuel system

The truck will start and idle then when you tap gas pedal to bring idle to normal truck will stall out. It happens every time you take foot off of gas pedal it stalls. I changed the plugs, rotor, fuel filter, wires and air filter. It still does the same thing. I even put 1 can of dry gas in to it incase of water. I have not gone far with the dry gas in it yet. Any idea's as to where to go next.

It has a carb.I will clean it real good and see if that helps/ I will let you know.

I did clean the carb and it did not make any difference. Any other suggestions?

Why would my truck die when I let out the clutch? Othewr than that it runs fine, tho it smokes a lot at start up. Also, the truck sat for five years being started only every six months.

My only sudjestion as a b2200 owner is check your intake, air filter, but I do now why its smoking mine does the same its the seal on the valve stems oil is dripping down the valves and getting underneath the valves and on top of you piston hope this has helped good luck 2 you

My Mazda truck started okay this morning, drove fine then I put in neutral and it sputtered and shut off. Now it’s hard to start, runs for a minute, sputters and shuts off.

I have a mazda b2200 1989 I came to a stop light and it studder and stalled I started it back up and came to the next stop and it studder bad I changed the fuel filter and cleaned the carb a little bit after I cleaned the carb it seemed to be better but started to studder again and then it stalled so I cleaned the carb again and it continues to do the same thing over and over please I really need to get my truck back on the road also when I start it up and put it into drive and reverse it stalls out any help would be greatful thanx

Yeah sometimes I have to press the gas pedal so it wont stall out

Engine Mechanical problem
1989 Mazda b2200 4 cyl Two Wheel Drive Manual

Hello,
I seem to have the same problem as need help bad. My truck runs well, but when you let off the gas it stalls. The carb has been rebuilt and the vac leaks as far as I know have been taken care of. I checked the idle solinoid as You told him and mine does not click when the power is on. When I jump the solinoid from the battry it clicks. When I hold the jumper in place it idles much faster. With the power on my meter reads 0.08 volts at the solinoid. Please help
Paul

i have a mazda b2200 1989 I came to a stop light and it studder and stalled I started it back up and came to the next stop and it studder bad I changed the fuel filter and cleaned the carb a little bit after I cleaned the carb it seemed to be better but started to studder again and then it stalled so I cleaned the carb again and it continues to do the same thing over and over please I really need to get my truck back on the road also when I start it up and put it into drive and reverse it stalls out any help would be greatful thanx

Engine Mechanical problem
1989 Mazda b2200 4 cyl Two Wheel Drive Automatic

I have a friend who has a mazda b2200 and the other day it just stoped running we started it and it ran for like 15secs and shut off. Its like what ever we prime into the float once its gone it shuts off could it be the fuel pump a fuse.