1993 SATURN SL2
130,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
replaced front brake calipers and bled air from bleeders, but now the brake pedal goes to floor before brakes apply. what do I do now?
Apr 1, 2013 at 5:38 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
If you bled the brakes with a helper and the pedal got pushed all the way to the floor the master cylinder likely got damaged. Crud and corrosion build up in the lower halves of the bores where the pistons don't normally travel, then when the pedal gets pushed far enough the lip seals run over that crud and get torn. Professionals either gravity-bleed with no helper or they never push the pedal more than half way to the floor.
Apr 1, 2013 at 6:43 PM
Advertisement