1992 Isuzu Amigo 2 6l Manual Will Fire Accident Had Replace Tie Rod Wouldn T

1992 ISUZU AMIGO
170,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
1992 Isuzu amigo 2.6L manual will not fire. It was in an accident and I had to replace a Tie rod. Then it wouldn't start.

I replaced the ignition coil. The whole distributor, wires, cap and rotor and the computer. It gets a bright blue spark but still will not fire.

The spark plugs are wet so it seems to be getting gas. I tested compression and it' good. It will not fire at all.
Nov 9, 2012 at 4:28 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,248 POSTS
If you have spark, fuel, and compression, check timing to see if it is out.
Nov 9, 2012 at 5:06 AM
Avatar
MITCHSTOVER
  • MEMBER
  • 1 POST
I did checked the timing. It turned out during the accident some wires in the wire loom were damaged. I soldered them and now i'm getting a message from the computer code 41 that it is not reviving a signal from the distributor and code 61 air flow sensor circut.

I opened the loom up and tested all the wires with my multimeter and can't seem to find any other short. Yet it will still will not fire.

I am out of ideas of what to try next.
Dec 30, 2012 at 4:26 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle