engine stalls

90,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
STONECUTTERWNY
  • MEMBER
  • 1 POST
I have a 92 Ford Ranger XLT automatic 2 wheel drive with a 3.0 6 cylinder engine. It has all sorts of problems. It will usually start right up but immediately stalls. If I rev the engine for a few minutes, it will idle after a while, but as soon as I put it in drive, it stalls. After a few tries, it will run, but will stall as soon as I stop. It only has 90,000 miles on it. I have replaced the fuel and air filters, the maf sensor, the throttle position sensor, and the coolant temp sensor and relay. The alternator has been tested and is fine as well. Please help me get to work.
Feb 5, 2011 at 11:36 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Check the fuel pressure if is within specs-if okay start by checking the IACV and EGR valve
Feb 5, 2011 at 12:24 PM
Avatar
NIQELIA
  • MEMBER
  • 1 POST
My Father in-law has the exact same truck he said to check the computer under dash on kick panel on passenger side.
Jul 22, 2017 at 5:21 AM
Avatar
STRAILER
  • ✓Experienced Mechanic
  • 55,721 POSTS
Great addition to this thread! Please feel free to help out whenever you are on the site :)

Cheers, Ken
Jul 24, 2017 at 4:46 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement