1991 Ford F-250 Gear issues

1991 FORD F-250
120,000 MILES • 5.8L • V8 • 4WD • MANUAL
Avatar
EMILYRROSIO
  • MEMBER
  • 3 POSTS
Truck starts fine. When clutch is pushed in slight hardness to get into gear. Clutch feels softer when releasing however the clutch was just replaced. I can put the truck in gear and when I press the gas it doesn't move. It only revs up. Ive tried lockin hubs and putting it in four but nothing worked. Also has a previous hard time of moving before I couldn't move it at all. It jerked and I had to really push down on the gas to make her move.
Dec 3, 2013 at 8:47 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Is the clutch slipping?
Dec 3, 2013 at 8:49 AM
Avatar
EMILYRROSIO
  • MEMBER
  • 3 POSTS
Not at all. Clutch feels pretty fine. My guess is the input shaft. It just won't move when its in gear
Dec 3, 2013 at 9:03 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Something isn't releasing. Did you install the clutch? If so, was there anything out of the ordinary?
Dec 3, 2013 at 9:49 AM
Avatar
EMILYRROSIO
  • MEMBER
  • 3 POSTS
No i didn't install it a shop did. I can take it and put it in gear just fine it just won't move
Dec 3, 2013 at 9:52 AM
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Something isn't releasing to engage the clutch. Did it work when you first got it back? Have you contacted them regarding the problem?
Dec 3, 2013 at 10:46 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.