Motor mount

1990 NISSAN HARDBODY
210,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
UNCLRONNY
  • MEMBER
  • 1 POST
I have a 1990 Nissan Hardbody kingcab truck, V6, 4WD, Manual trans. Has anyone had the experience of changing the driver's side motor mount. Looks like lots of stuff has to be removed, I am not sure to go at this from the top or from underneath. any help at all would be greatly appreciated, Ron
Jun 4, 2011 at 5:36 PM
Advertisement
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
I haven't done it on this vehicle before but for most vehicles, to remove the engine mount you need to anything that is obstructing the job. The engine would also have to be supported with a floor jack and raised slightly to facilitate the mount removal.
Jun 5, 2011 at 9:16 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.