Motor mount

1990 NISSAN HARDBODY
210,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
UNCLRONNY
  • MEMBER
  • 1 POST
I have a 1990 Nissan Hardbody kingcab truck, V6, 4WD, Manual trans. Has anyone had the experience of changing the driver's side motor mount. Looks like lots of stuff has to be removed, I am not sure to go at this from the top or from underneath. any help at all would be greatly appreciated, Ron
Jun 4, 2011 at 5:36 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
I haven't done it on this vehicle before but for most vehicles, to remove the engine mount you need to anything that is obstructing the job. The engine would also have to be supported with a floor jack and raised slightly to facilitate the mount removal.
Jun 5, 2011 at 9:16 PM
Advertisement