SPONSORED LINKS

Clutch

Tiny
SMART ART
  • MEMBER
  • 1988 CHEVROLET S-10
  • 6 CYL
  • 2WD
  • MANUAL
  • 335,987 MILES
I have replaced the clutch master and slave cyl. And I cant get it to bleed, or should I say get presure to the clutch only line I did not replace was from master to slave looked good and dry no cracks in line fittings are good and tite no cross threading, have bleed it as per the book
SPONSORED LINKS
Monday, December 27th, 2010 AT 3:28 PM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,709 POSTS
If you have properly done the work and there is no pressure, either you have a bad part or the it wasn't installed correctly and isn't placing pressure on the pressure plate. Check to see if that is properly installed.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Friday, January 7th, 2011 AT 5:37 AM

Please login or register to post a reply.

Related Transmission Clutch Slave Cylinder Content

Throwout Bearing - Secondary Cylinder Replacement
GUIDE
Throwout Bearing - Secondary Cylinder Replacement
A throwout bearing/secondary cylinder is used to apply force against the clutch pressure plate to release the clutch disc and should be replaced as part of the normal clutch...
VIEW MORE

Sponsored links