MAZDA ENGINE

I Bought The Truck With A Bad Head, I Replaced The Head And Put It Back Together, It Gave Me A Code For An Ect, So I Changed That Then...

I Need A Vacuum Diagram.

This Vehicle (listed Above B2600i) Has The 6-pin Green Mecs And 1-pin Green Tel Connector Under The Hood. Started, But Quit Immediately....

I Tried To Clean The Maf (with Maf Spray) And Throttle Body (throttle Body Cleaner) And Placed Seafoam Fuel Injector Cleaner In Gas Tank...

Dear All, I Have A Problem With My Car, The Car Doesn't Start Anymore Due To An Accident. After Repairing The Body, The Car Is...

I Changed The Battery And The Mass Airflow Sensor & Diagnostic?

Okay, The Camshaft Sensor, Crankshaft Sensor Vacuum Lines, Spark Plugs, And Coil Packs Have All Been Replaced. Did The Timing, It Still...

1. When I Check The Injector Harness, With The Key To On, I Get 12 Volts On Both Pins. Is That Supposed To Be? Much Of The Internet Says...

Car Suddenly Would Not Start After Replacing The Valve Cover Gasket And Camshaft Sensor. I Tried Putting The Old Camshaft’s Sensor Back On...

We Replaced The Chain As It Had A Bit Of Noise, We Still Have Some Noise Coming From The Bottom Of The Engine. This Is The 2.5 Sky Active...