Mazda Engine

Browse Mazda Engine questions and answers. Choose a question that matches your symptoms.

3,598 discussions


Turbo Replacement Oil Change Requirement

2010 MAZDA CX7
My Turbo Failed At 75,000 Miles And My Wife Was Six Hours From Home. She Took Our Vehicle To The Local Mazda Service Location. The...
4 ANSWERS
Asked by Kevin Weisinger

Slow Engine Crank When The Engine Is Warm

2010 MAZDA 3
Vehicle Starts Right Up When The Engine Is Cold But Very Slow To Turn Over And Crank When The Engine Is Warm.
2 ANSWERS
Asked by lelliott46@yahoo.com

2010 Mazda 3 Car Wont Start

2010 MAZDA 3
I Put More Oil In It Cause It Was Low I Put Way To Much On Accident Drove Down The Block To Go To Friends House To Drain The Oil Out As Soon...
1 ANSWER
Asked by kurtj4

2010 Mazda 3 Rattling

2010 MAZDA 3
When I Come To A Complete Stop, I Hear A Rattling Sound. Sounds Like Its Under The Hood
1 ANSWER
Asked by Angie63

2010 Mazda CX7 Throttle Body Is Dirty

2010 MAZDA CX7
I Want To Wash The Throttle Body On My Mazda Cx7 2010. My Question Is Will I Have To Reset Or Reprogram Anything After Washing It. When The...
3 ANSWERS
Asked by negealin

Mazda 3 2010 Automatic

2010 MAZDA 3
Car Has 20k Miles. Car Bogs Down At 40mph. It Sounds Like It Is "blowing Bubbles" Under Water. If I Give It Heavy Gas The Car Powers Through...
1 ANSWER
Asked by johnscalzo1654

2010 Mazda 3 Engine Won't Start After Car Wash

2010 MAZDA 3
I Have 2010 Mazdaspeed3. My Car Is Tuned With Stage 2 And Ecu Is Tuned With Cp-e Standback And Pnp Harness. The Hood Of Engine Area Has A...
1 ANSWER
Asked by austin1kr

Developed A Rough But Temporary Idle?

2009 MAZDA MX5
After Replacing A 9-year-old Battery My Mazda Developed A Rough But Temporary Idle. At Every Stop It Will Idle Rough For About 5 Seconds...
3 ANSWERS
Asked by surfergurudude

Failure To Start?

2009 MAZDA B2500
My Vehicle Listed Above Bt50 3.0 Crd Is Just Cranking Without Starting. It Does 1 Kick Once I Spray The Starting Fluid In The Throttle And...
5 ANSWERS
1 VIDEO
7 IMAGES
Asked by Tariroyashe Ndhlovu

PCM/BCM/TCM Pinout Needed?

2009 MAZDA 6
Bad Ecm. Misfire On #4 Changed Coil Because It Melted, And It Did It Again. I Tested The Line Going To That Specific Coil And The Pcm...
1 ANSWER
2 IMAGES
Asked by Pandamonic

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickDrain PlugEstimateFlexplateGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CoolerOil Fill CapOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Mazda question