Mazda Transmission

Browse Mazda Transmission questions and answers. Choose a question that matches your symptoms.

698 discussions


I Have An Automatic 1988 Mazda 323. I'm Trying To...

1988 MAZDA 323
I Have An Automatic 1988 Mazda 323. I'm Trying To Flush The Transmission Fluid And Replace The Gasket, But I'm Not Sure How To Get To The...
1 ANSWER
Asked by Anonymous

Switched From Automatic To Manual Transmission?

1988 MAZDA RX7
How Do I Hook Up The Wires On The Transmission? Ive Tried Everything. I Switched From Auto To Manual Transmission In My 1988 Mazda Rx7. How...
1 ANSWER
Asked by Kricket0326

Is There An Adjustment On Transmission?

1988 MAZDA 323
2nd Gear Went Out. Drove In L2 For Awhile Changing From L2 To Drive. Still Have Reverse L1 An L2 And 1st Gear.is There An A Band Adjustment...
1 ANSWER
Asked by michael weems

1988 Mazda 626

1988 MAZDA 626
Car Runs Fine And Clutch Seems Ok But When You Put It In Gear It Does Not Move
1 ANSWER
Asked by cpetera

1988 Mazda B2200 CLUTCH

1988 MAZDA B2200
I Filled The Master Cylynder For The Clutch With Fluid But Still Have Little Or No Clutch, Is There A Way To Bleed It?
1 ANSWER
Asked by Bullittsdad

1988 Mazda RX7 Auto Trans

1988 MAZDA RX7
Ok I Have An 1988 Mazda Rx7 Se N/a It Has An Auto Transmission And Then Engine Starts And Runs Fine But When You Put It In Any Gear But Park...
2 ANSWERS
Asked by driftermirage

Connecting The Clutch Starter Switch?

1987 MAZDA 323
I Have The Vehicle Listed Above Fwd, 3 Door, 5sp. Battery Is Working And Electrical Systems Come On When Attempting To Start The Car. I...
3 ANSWERS
6 IMAGES
Asked by blck323ownr

Hello Im Trying To Replace The Front Wheal Bearing On...

1987 MAZDA MPV
Hello Im Trying To Replace The Front Wheal Bearing On A 1987 Mazda Mpv And Now The Computer Says They Didnt Make A Mazda Mpv That Year?
1 ANSWER
Asked by Jamiemoore25

I Took Down The Trans And Replace The Clucth And The...

1987 MAZDA B2600
I Took Down The Trans And Replace The Clucth And The Pilot Bearing And Pressure Plat And The Pedal Sit Real Low
1 ANSWER
Asked by mike sensor

1987 Mazda Truck Clutch

1987 MAZDA TRUCK
Thro- Out Bearing Is Not Going Far Enough To Disengage The Clutch. New Master And Slave But Will Not Disengage
1 ANSWER
Asked by rnicolis

Browse other repair topics

Browse by repair topic
Bearing HubCV AxleDifferentialDrive ShaftTransfer CaseTransmissionWheel BearingWheel Stud

    Can’t find your issue?

    Ask a new Mazda question