GMC


Heater/ AC Blower Motor Not Working Properly

1995 GMC JIMMY
Blower Motor Was Working Fine Then Shut Off And Then Came Back On But Shut Off For Good. So, I Changed The Resistor But That Didn't Help...
1 ANSWER
2 IMAGES
Asked by George Kocher

Low Oil Pressure At Idle And Hot

2007 GMC YUKON
Dear Experts, I Have The Suv Listed Above Denali. I Noticed That My Oil Level Gauge Drops Below 20. The Truck Is Running Fine With No...
13 ANSWERS
6 IMAGES
Asked by eddy1991

Alternator Overcharging

2007 GMC ENVOY
I Was Told By A Shop That My Alternator Was Overcharging, And I Needed A New One, Rather Than Let Them Do It I Did It. I Tested The...
3 ANSWERS
Asked by Steve620

Four Wheel Drive Does Not Work

1994 GMC SONOMA
When I Push The 4hi Button Nothing Happens. I've Checked The Fuse, It's Good, Checked The Fuse For Power And It Has Power. The 2hi...
1 ANSWER
2 IMAGES
Asked by rkp209

Shuts Off While Driving Fifty MPH

1996 GMC C1500
I Go To Crank It Up No Check Engine Light On. So, When I Drop It And Drive And Drive It Like 4 Or 5 Blocks It Cuts Off But It's All, But...
1 ANSWER
Asked by Daron henry

Cruise Control Does Not Work When Headlights Are On

2006 GMC SIERRA
Hi There, Nine Months Ago I Converted All Bulbs To Led And Put The Correct Relay In It To Fix The Hyper Flash. Never Had An Issue, Until Now...
3 ANSWERS
2 IMAGES
Asked by fye456

A/C Not Working Properly

2014 GMC YUKON
When We First Start The Car The A/c Runs Fine. Usually After About 30-45 Minutes The Amount Of Air That Comes Out The Vents Gradually...
3 ANSWERS
Asked by lockamya

Engine Runs Poorly, Burns Gas

2003 GMC C2500
Catalytic Converters Have Been Gutted Before I Got The Truck Not Showing Check Engine Light But Getting Fuel System Lean Bank 1 An Bank 2....
1 ANSWER
Asked by sgordon80

Engine Cranks But Does Not Start After Replacing The...

1996 GMC SUBURBAN
Put In New Crankshaft Position Sensor And Truck Will Not Start. Turns Over But Won't Start.
10 ANSWERS
9 IMAGES
Asked by Ken Norman

Where Is The Fuse That Powers The OBD2?

2005 GMC ENVOY
Obd2 Has No Power When Code/diagnostic Plugged In.
2 ANSWERS
1 IMAGE
Asked by KSCarQues#1
Ask a new GMC question