GMC


Oil Pressure Sensor Keeps Going Bad

2010 GMC SIERRA
I Have Changed The Oil Pressure Sensor For The Third Time And Also The Screen Inside Of It. Except The Last Time I Remove It And Did Not Put...
3 ANSWERS
3 IMAGES
Asked by Pete C

Check Engine Light Code P0420

2008 GMC ENVOY
What Exactly Is This Code And What's Wrong? Is It A Simple Fix?
6 ANSWERS
9 IMAGES
Asked by Tapoutzaddy

Heated Seat Plug Replacement

2011 GMC YUKON
I Pinpointed My Intermittent Heated Seat Problem To A Pin In One Of The Plugs Connecting To The Seat Control Module. The Pin Overheated The...
11 ANSWERS
4 IMAGES
Asked by gmac7

Computer Reset Instructions Needed

1994 GMC SONOMA
Just Put A New Motor In It Need To Reset The Computer How Do I Do That?
1 ANSWER
1 IMAGE
Asked by ericanh2221

Power Steering Gear Box

2001 GMC SONOMA
I'm Doing A Front End Kit On This Truck, Customer Complained Of A Loose Steering Wheel And Wanted To Replace The Steering Box. Can't...
23 ANSWERS
20 IMAGES
Asked by cannon1349

Vibration Or Grinding Noise

2014 GMC SIERRA
There Is A Vibration Or Grinding Noise At Times. It Almost Sounds Like You Are Driving Over Rumble Strips Even Though You Are Not. This Is...
1 ANSWER
Asked by Jeff Lyman

Engine Swap

1986 GMC TRUCK
I Would Like To Take The Engine Out Of The Truck Listed Above And Put It In My 1991 Chevrolet 2500. Will It Mount?
3 ANSWERS
Asked by Bymymimi@yahoo.com

Misfire, Code P0301

2001 GMC JIMMY
P0301-cylinder 1 Misfire Detected. I Can't Find The Misfire.
1 ANSWER
Asked by teerock1

Auto Meter Fuel Gauge

1999 GMC YUKON
I Installed A Fuel Gauge Not Using The Fuel Gauge On The Original Factory Cluster. I Installed The Fuel Gauge To The Same Wire From The...
3 ANSWERS
2 IMAGES
Asked by Joe denali

Rear Upper Control Arms Need To Be Replaced

2003 GMC ENVOY
My Rear Upper Control Arms Needed Replaced. When I Took Them Off The Inner Part Of The Sub Frame It Attaches To Was Rusty And Rusted Out...
3 ANSWERS
8 IMAGES
Asked by König Sekulich
Ask a new GMC question