GMC


1999 GMC Yukon Brakes

1999 GMC YUKON
Whenever I Squeeze My Brakes To Stop My Vehicle, The Brake Pedal Goes Pretty Low To The Floor And I Just Replaced My Brake Pads. My Problem...
1 ANSWER
Asked by nfltwin

1994 GMC Jimmy Oil Pressure

1994 GMC JIMMY
Is It Normal For My Oil Pressure Guage To Fluctuate. At Idle It Drops Down, & When The Rpms Come Up So Does The Guage ?
1 ANSWER
Asked by jimberrigan

1990 GMC C1500 Starts Then 2 Sec. Later Dies

1990 GMC C1500
I Have Checked Fuel Filter, Battery And Alternator Are Good, Ignition Module Has Tested Good, Found Vacumm Lines Bad And Fixed. Don't Know...
3 ANSWERS
Asked by brettyboy

1997 GMC C1500 Leaks

1997 GMC C1500
I Have A Friend That Has Changed The Front Seal And The Oring Behind The Shaft That The Tork Converter Fits On,and Also Took The Pump Out...
1 ANSWER
Asked by Alan Duke

1979 GMC C1500 Brakes

1979 GMC C1500
The Brake Rotor On The Right Front Is Sticking. I Changed The Rotor And Still Have The Same Problem Where Else Should I Look For The Problem...
1 ANSWER
Asked by Paul Cruce

1993 GMC Jimmy Firing Order Of Spark Plugs

1993 GMC JIMMY
Need To Know The Direction Of The Firing Order Of Spark Plugs
2 ANSWERS
1 IMAGE
Asked by captstenille

1997 GMC Jimmy Starting

1997 GMC JIMMY
My Engine Won't Turn Over When Trying To Start. I Just Get A Clicking Noise, Would That Be The Starter? Alternator? Or Battery?
1 ANSWER
Asked by James311

How To Install A Fuel Sensor In The Tank

2006 GMC ENVOY
Six Cylinder Four Wheel Drive Automatic 60,000 Miles. My Gas Gauge Is Staying On Empty All The Time And The Check Engine Light Comes On...
3 ANSWERS
Asked by bradystoo7

1997 GMC Jimmy

1997 GMC JIMMY
1997 Gmc Jimmy Engine Size Unknown Two Wheel Drive Automatic 300000 Miles How Do You Replace The Mass Air Flow Sensor? Can You Enlarge...
1 ANSWER
Asked by Teresa Trammell

2002 GMC C2500

2002 GMC C2500
I Will Be Driving Down The Road And It Will Die. I Let It Sit For A Little While And It Will Sart Again. Was Told Fuel Filter So I Changed...
1 ANSWER
Asked by 2500hd
Ask a new GMC question