GMC
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
Transfer Case Control Module
System Had 12.6 Volts. I Did A Volt Drop Test On My Grounds. The Transfer Case Control Module Ground To Chassis Volt Drop Was 11.8 Volts....
Asked by BLCKLBRTRVR
Intermittent Engine Floods When Starting
When I Try To Start It Sometimes It Floods And I Can Unplug The Fuel Injector And Start It Until It Runs Out Of Gas. Plug It Back In And It...
Asked by CraigA54
Replacing Brake Line And Pads Bleeding Instructions...
Replacing Rear Line And Pads. Also Need To Know About How To Bleed When Done.
Asked by MPCarter
Transfer Case Control Module
When Checking For 5vlt At Signal Wire (lt Grn/blck + Blk/wht)at Female End Of Harness At Encoder Motor. I Don't Get A Reading Until I Put...
Asked by BLCKLBRTRVR
Water In Gas Tank
I Jump Started My Car And Let It Sit Running, It Shut Off And Wont Start. I Think There Is A Lot Of Water In My Gas Tank, But I Had Already...
Asked by Dawn Grosinsky
Will Not Start After Replacing Timing Chain
Replace Timing Chain, Now In Won't Start. Lined Everything Up Like It Was. Does It Have A Computer?
Asked by Rich4200
Transfer Case Encode Motor Short To Ground Or Open
With Key On Using Dmm With Actuator Unplugged And Dmm One End Ground To Frame And Other Lead On (a) Grrrn/black I Get 5.06 Volts When I...
Asked by BLCKLBRTRVR
Should There Be A Rough Rotation On Crankshaft?
I Noticed While Trying To Replace Pushrod On 454ci. The Crankshaft Rotate Bit Stiff About 180 Degree Almost A Full 360 Degree. Not Only That...
Asked by Black_mask07
Rear Defroster Not Working
One Of The Leads On The Back Window Fell Off And I Was Able To Glue It Back On.
I Put Test Light On Each Of The Heat Strips And I Have...
Asked by Steve620
Crank, No Start, No Spark
Truck Ran Fine, Parked In Yard. Next Morning Would Not Start. Turned Over Fine. Checked Spark. No Spark From Ignition Coil. Checked...
Asked by pillard1
Ask a new GMC question
