GMC Drivetrain
Browse GMC Drivetrain questions and answers. Choose a question that matches your symptoms.
1,346 discussions
1993 GMC Other Transmission
I Have A 1993 Gmc Vendura 3500 5.7l Auto Transmission And I Cannot Put It In Gear From Park After I Start It I Got To Shut It Off Than Start...
Asked by TimHinton
Trans Wont Shift
Found Speedo Inop, Fuses Ok And Can See The Vss Has Been Changed
I Feel If The Speedo Does Not Work Trans Will Not Shift What Controls...
Asked by bvtransam
Swaping Motors
Ok I Got A 1983 Gmc S10 Its The Shell I Got A 1989 Chevy S10 With And Motor And Trany But Ihave 700r4 I Think Because The Guy That Had It...
Asked by chevvymane
I Have Replaced The Master Cylinder And Slave Cylinder...
I Have Replaced The Master Cylinder And Slave Cylinder On The Clutch And Still No Pedal Pressure...any Ideas?
Asked by Anonymous
Some One Cut A Wire For My 4x4 The Wire Run From The...
Some One Cut A Wire For My 4x4 The Wire Run From The Front Acutrator To The Back But I Can Not Find Anything That It Goes To Its A Brown...
Asked by Anonymous
Replaced Transfer Case For 4x4 However Only Getting...
Replaced Transfer Case For 4x4 However Only Getting Two Wheel Drive. What Could Be The Problem?
Asked by Anonymous
If The Front Axle Of The 4x4 Is Not Turning But When...
If The Front Axle Of The 4x4 Is Not Turning But When Engaged The Front Drive Shaft Is Turning But The Tires Are Not Engaging What Is The...
Asked by Anonymous
Will A Tranny From A 95 K-1500 Blazer Work In My 93...
Will A Tranny From A 95 K-1500 Blazer Work In My 93 4x4 1/2 Ton Sierra? If Not What Years /styles Will Work? How Many 4l60e Dtyles Are There...
Asked by Anonymous
I Have A 1998 Gmc Safari 4.3 V6 With 80,000 Mi. On It...
I Have A 1998 Gmc Safari 4.3 V6 With 80,000 Mi. On It And Auto. Transmission. What Would I Need To Change, To Place This Engine And...
Asked by ernie2012
4l60e Transmission
I Have A 1993 Gmc Jimmy 4x4 4.3 W Engine Code With The 4l60e Trans I Was Looking For A Replacement Trans And Have Found Out That It Is 1993...
Asked by jdchevyguy1
Browse other repair topics
Can’t find your issue?
Ask a new GMC question
