Ford Fusion Computer

Browse Ford Fusion Computer questions and answers. Choose a question that matches your symptoms.

11 discussions

Intermittently While Driving A Wrench Appears On My...

2019 FORD FUSION
So I Took It To An Autozone To Have Them Run A Diagnostic On It And It Came Back As A Sensor Issue. They Told Me To Disconnect The Negative...
2 ANSWERS
Asked by Kemaria

Reduce Power Mode?

2014 FORD FUSION
I Have A 2014 Ford Fusion Se With The 1.5l Engine. My Wife Was Driving It To The Store, And On The Way Back, The Dashboard Displayed A...
3 ANSWERS
Asked by pcguy2

Codes Codes P0300, P0303, And P0304, Engine In Limp...

2013 FORD FUSION
I Have The Car Listed Above That While On The Road To Texas Stalled Out On My Wife And Basically Went Into Limp Mode. Bought And Obd2 Reader...
1 ANSWER
Asked by jshade93@yahoo.com

How Do I Get It Out Of Limp Mode?

2013 FORD FUSION
I Was Driving On The Freeway When It Sounded Like Rubber Flapping From The Tire And The Engine Shut Off. As Soon As I Realized I Lost Power...
2 ANSWERS
5 IMAGES
Asked by Jnnfrosal82

Went Into Limp Mode While Driving It The Other Night...

2013 FORD FUSION
I Pulled Over, The Engine Wasn’t Very Hot And I Had Coolant In The Overflow. I Let The Car Set A Few Hours, Went To Start It And Warning...
3 ANSWERS
2 IMAGES
Asked by Sshelby

DTC P2196 And P2198?

2012 FORD FUSION
Cannot Complete Drive Cycle?
1 ANSWER
1 IMAGE
Asked by garlandperrry

ECM Or Electrical

2012 FORD FUSION
I Was Installing An External Speaker And Running The Wires Through The Firewall But I Forgot To Disconnect The Positive Wire From The...
1 ANSWER
Asked by jakewoody3

No Communication

2011 FORD FUSION
Communication Issue. Emissions Will Not Pass The Vehicle Due To Communication Error.
7 ANSWERS
5 IMAGES
Asked by uswjsr42

Where Is The OBD Port Located?

2010 FORD FUSION
I'm Receiving An Error When Plugging My Scan Tool. It Won't Connect. Trying To Locate The Power Port.
1 ANSWER
3 IMAGES
Asked by jgstrick1

2007 Ford Fusion Ignition Coil/pcm

2007 FORD FUSION
My Car Has Burnt The #5 Coil Up Everything I Can Find Says I Need To Replace The Pcm, Not A Problem. My Question Is Do I Need To Replace...
1 ANSWER
1 IMAGE
Asked by rewelch83

Browse other repair topics

Browse by repair topic
SymptomsAir FilterBlockCamshaftComputerCrankshaftCylinder HeadIntake ManifoldMAP SensorMass Air Flow SensorOilOil ChangeOil FilterOil PanOil Pressure SensorOxygen SensorPistonReplace/RemoveSerpentine BeltStarterThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Ford Fusion question