Ford Drivetrain
Browse Ford Drivetrain questions and answers. Choose a question that matches your symptoms.
7,761 discussions
Ford Mustang 1966 Restoration Re: Starter Ring Gear
On This 66 Car. The Original Automatic 289 Engine Was Replaced With A High Performance 289. The Starter Ring Gear Has 160 Teeth. The...
Asked by woodly
Pilot Bearing Size
I'm Doing A C-4 To T-5 Transmission Swap In My Car. The Pilot Bearing That I Received In The Clutch Kit Is 44 Thousandths Smaller Than...
Asked by jarmagn1
My Transmission Hard Line Blew Off Of The Fitting That...
My Transmission Hard Line Blew Off Of The Fitting That Was Attaching It To The Other Section Of The Hard Line Which Attaches To My Radiator...
Asked by zsprague
My 1965 Mustang Has A 3 Speed Manual Transmission (...
My 1965 Mustang Has A 3 Speed Manual Transmission (unsynchronized 1st Gear). My Question Is About A Clanking Noise Emanating From The Trans...
Asked by vapor
Whiffing Sound
I Just Acquired A 1965 Ford Falcon Ranchero (straight 6, 200cid(?), Rebuilt Carb, Switched From Manual Trans Stick In The Column, To...
Asked by Sauxuca
1965 Ford Mustang STUCK IN GEAR
Transmission Problem
1965 Ford Mustang 6 Cyl Two Wheel Drive Manual
Hi Have 65 Mustang Coupe, 200 6cyl, 3spd Manual. The Transmission...
Asked by jelliny
1965 Ford Mustang Moves And Steers Fine In Reverse...
1965 Ford Mustang V8 Two Wheel Drive Automatic
My 65 Mustang Has Been Sitting For About A Year And When I Wne To Tdrive It, I Put It In...
Asked by Mike1981Mustang
1965 Ford Fairlane Clutch Problem
My Car Has A 289 With 2barrel Carb And 3 Speed Column Shifter.moving From A Stop The Car Shakes Violently As I Let Out The Clutch Pedal.once...
Asked by johnw
I Have A 351 W Its A 1970 Model Engine With A Top...
I Want To Change To An Automatic Tranny And It Has A 411 Rear Gear .which Tranny Would Be My Best Fit For Street And Gas Mileage.
Asked by ncbeachboy
1964 Ford Falcon
Shakes Or Wobbles Problem
1964 Ford Falcon V8 Two Wheel Drive Automatic
Got The Engine Replaced With A Rebuilt 302. Worked Fine....
Asked by daniel__chavez
Browse other repair topics
Can’t find your issue?
Ask a new Ford question
