Ford Drivetrain
Browse Ford Drivetrain questions and answers. Choose a question that matches your symptoms.
7,763 discussions
1984 Ford Bronco I Need Help!
Transmission Problem
1984 Ford Bronco 6 Cyl Four Wheel Drive Automatic
Hi, I Have A 84 Ford Bronco 2 Im Trying To Replace The...
Asked by joeydsellers
1984 Ford E-Series Van Tranny Wont Go In Reverse...
Ford C6 Tranny Wont Go In Reverse When Cold After Driving Around The Block It Will Go Intoreverse Fine, This Is In A Motorhome With 57,000...
Asked by jamracing21
1984 Ford F150 NON SHIFT
This Transmission Was 2qts Overfilled, So I Changed Filter And Refilled To Proper Level, Now I Have To Get It Up To 40mph To Change To 2nd...
Asked by FINDANSWERNOW
1984 Ford Mustang Random Stalling When Clutch Is...
Other Category Problem
1984 Ford Mustang Engine Size Unknown Two Wheel Drive Manual 93699 Miles
I Have A 1984 Ford Mustang With The...
Asked by 84stangguy
Engine Stops Running After I Let Out The Clutch When...
I Have A 1983 Ford 7000 Truck With A 3208 Caterpillar Diesel Motor When I Turn The Key Seems Like It Has A Dead Battery But When I Put The...
Asked by Heldman Jr Don
Transmisson Swap, How Difficult Would It Be To Put In...
I Had Seen One At The Junkyard. It Was Wrecked So I Know It's Operational.
Asked by tcook71
Help
I Have A Ford F250 351 Ho 4 Speed That Wont Go Into Gear It Has A Brand New Clutch What Could It Be I Drove It Yesterday Just Fine And I...
Asked by FordF250351Ho
Which Way Does The Front Drive Shaft Go On My Truck...
Which Way Does The Front Drive Shaft Go On My Truck Does The Small Yoke Go Towards Front Dif Or Toward Transfer Case
Asked by Anonymous
I Have A 1983 Ltd Crown Victoria With A 5.0 Engine. I...
I Have A 1983 Ltd Crown Victoria With A 5.0 Engine. I Have Taken It To 3 Shops And They R Stomped. I Starts Up, Runs And Shuts Down. When U...
Asked by Edwards77
Are The Bolts Holding The Starter In Place Reverse Or...
I Am Tring To Replace The Starter On My '83 Fairmont And Can Not Seem To Loosen The Bolts. I Was Wondering If They Were Reverse Threaded Or...
Asked by franktims
Browse other repair topics
Can’t find your issue?
Ask a new Ford question
