DODGE TRUCK COMPUTER

Found 18 results

Select a filter to limit the results

Clear Codes Diagnostic Connector ALDL Limp Mode - Reduced Power Location No Communication Read Codes Replace/Remove

When I Hook Up My Actron Scanner Tool To My Obd Port...

Message. My Scanner Works On All My Other Vehicles, (except My 1991 Bronco-that Needs It's Own Scanner). I Changed The Dashboard...

Asked by kartz ·

11 ANSWERS

1 IMAGE

1999

Computer

A car's computer or PCM - ECM (powertrain control module - engine control module) is designed to read various sensors such as the crankshaft position sensor to deliver...

1997 Dodge Truck Tranny Stays In Limp Mode

Transmission Problem 1997 Dodge Truck 6 Cyl Automatic Tranny Was Rebuilt The Od Sprag Directclutch Steels Rear Extension Housing...

Asked by Corey Hodges ·

7 ANSWERS

1997

Ecm Change

I Accidentally Fried The Brain On My Truck. Ordered A "plug And Play" With The Correct Matching Number. But It Still Will Not...

Asked by Jason Martin ·

16 ANSWERS

2002

2003 Dodge Truck Getting Code P0700

My Transmission Is Not Shifting Out Of First Gear Properly And After It Does Shift It Will Not Shift Again. I Got A Fault Code P0700. Will...

Asked by krsmith10 ·

1 ANSWER

2003

2001 Dodge Truck Injector / PCM

Electrical Problem 2001 Dodge Truck V8 Four Wheel Drive Automatic 100.00 Miles I Have Checked The Wiring Back To The Pcm Now Where Do...

Asked by tltfish ·

2 ANSWERS

2001

1998 Dodge Truck No Communication With Scanner

All Wires At Data Link Are Good But Scanner Does Not Communicate.

Asked by papabear2009 ·

1 ANSWER

1998

1998 Dodge Truck Clearing A 1389 Code

How Do You Clear The 1389 Code, No Communications Between The Automatic Shut Down Relay And The Pcm?

Asked by SProctor79 ·

1 ANSWER

1998

2002 Dodge Truck Ecu

Computer Problem 2002 Dodge Truck V8 Two Wheel Drive Automatic 132.91 Miles I Have A 2002 Dodge Ram 1500, Not That Long Ago I Bought A...

Asked by chewy4u ·

1 ANSWER

2002

Engine Electronic Control Module?

Why Can't I Find It Thought It Would Be On Firewall

Asked by Doug Potter ·

2 ANSWERS

1 IMAGE

1989

1999 Dodge Truck Pcm

I Changed The Engine, The Truck Has Been Sitting For A Couple Years. Wont Start My Book Says The Oil Or Batt Light Should Come On To Verify...

Asked by duanehudson ·

1 ANSWER

1999

Ask a new Dodge Truck question

Sponsored links

Ask a Car Question. It's Free!

SPONSORED LINKS

Online car repair manuals

Online car repair manuals

© 1999 - 2024 2CarPros, Inc.