Dodge Ram Crankshaft Sensor Replace/Remove

Browse Dodge Ram Crankshaft Sensor Replace/Remove questions and answers. Choose a question that matches your symptoms.

8 discussions

Replaced The CAM Sensor As Well As The CRANK Sensor...

2005 DODGE RAM
My Truck Died While I Was Driving. Hooked It Up To The Scanner And It Threw A Cam Sensor Code, Replaced The Cam Sensor As Well As The Crank...
1 ANSWER
Asked by angelaputt

Engine Code Said Bad Crankshaft Sensor. Replaced With...

2001 DODGE RAM
Engine Code Said Bad Crankshaft Sensor. Replaced With New Sensor, Engine Runs Worse Than Before And Sounds Like Its Out Of Time. Any Ideas?
1 ANSWER
Asked by Anonymous

Crank Position Sensor?

1999 DODGE RAM
My Truck Will Start And Run Fine. I Get Between .97 And 1.3 Volts At An Idle. It Starts Running Slightly Rough At An Idle And Eventually...
4 ANSWERS
5 IMAGES
Asked by Heisafastone

99 Dodge Ram

1999 DODGE RAM
I Have A 99 Dodge Ram 2500 Quad Cab With 30,000 Miles 5.9 L. Automatic, My Prob Is Truck Started Out By Just Stalling Occ. Then I Did A...
2 ANSWERS
Asked by truck6

1996 Dodge Ram

1996 DODGE RAM
I Have Put A 1994 Motor Into This Vehicle And For Some Reason It Still Will Not Start. I Am Getting Fuel To The Fuel Bar But It Will Not...
1 ANSWER
Asked by amieelynn

1996 Dodge Ram Crank Sensor

1996 DODGE RAM
How Do I Go About Replacing The Crank Sensor? Thanks, Doug
4 ANSWERS
Asked by hogbgone

My Dodge Van Stalls Intermittently. It Will Start...

1994 DODGE RAM
My Dodge Van Stalls Intermittently. It Will Start After Waiting For 10 To 40 Minutes. I've Replaced Ignition Switch And Module, Coil, Pick...
2 ANSWERS
2 IMAGES
Asked by Anonymous

1994 Dodge With Cummins Diesel.check Engine Light,wait...

1994 DODGE RAM
1994 Dodge With Cummins Diesel.check Engine Light,wait To Start Light Will Not Come On.alternator Will Not Charge,overdrive Will Not Work...
1 ANSWER
Asked by Anonymous

Browse other repair topics

Browse by repair topic
LocationReplace/Remove

    Can’t find your issue?

    Ask a new Dodge Ram question