DODGE INTAKE MANIFOLD

While Changing The Rocker Arm And Rocker Arm Shaft I Dropped A Bolt And Had To Remove The Intake Manifold. After Removing The Bolt I Cannot...

Hi I, M Have Problems With A My Carb Boiling Its A New 360 Engine With "j" Heads Enginge Temp Is At 210f At The Intake Manifold Take By A...

I Had A Remanufactured Engine Installed In 2006. They Day I Picked Up The Vehicle I Noticed That There Were Vibrations And A Dragging Noise...

My Vehicle Was Running Rough So I Had The Fuel Injectors Cleaned And The Vehicle Ran Great For About A Month After Which It Started Running...

I Have A Sensor Unplugged That Is Throwing The Computer Off And Causing It To Shut Off And Not Wanna Crank For Awhile. It Is Located Right...

Replaced The Intake Manifold But It Does Cover One Of The Rear Passages. What Am I Doing Wrong N How Can I Did It? I Would Also Like To See...

What Would Cause The Truck To Just Start Up And Run About Half Mile Then Shut Off, Wait A Few Minutes Pump Gas Like Heck Until It Fires Up...

Hi There I Had My Water Pump Replaced Just Yestreday (and Mechanic Adedd To That Also Replacment Of Thermostat, Thermostat Housing, Valve...

Engine Light Came On, Had Code Read And It Is P2004 Intake Manifold Runner Control Stuck Open Bank 1. Is This Major? Can I Replace It? Is...

When Truck Is Driving Everything Is Fine, But Idles Very Rough When Stopped. This Began Just Prior To A Full Tune Up And Has Continued...