Chrysler Drivetrain
Browse Chrysler Drivetrain questions and answers. Choose a question that matches your symptoms.
1,004 discussions
I Need To Replace My Wheel Bearing On The Passenger...
I Need To Replace My Wheel Bearing On The Passenger Side And Cannot Get To The 3 Bolts On The Rear Of The Wheel Hub. Due To The Gear For The...
Asked by 96newyorker
1996 Sebring LXi A Im Using 2-3 Quarts Of Transmission...
I Drive A 1996 Sebring Lxi And I Have Some Problems With It, Im Using 2-3 Quarts Of Transmission Fluid A Month, When I Stop And Go Again A...
Asked by Gcayley
My Brother Wants Me To Change The Transmission Fluid...
My Brother Wants Me To Change The Transmission Fluid And Filter On His Plymouth (or Dodge?) Van. I Have Done This On My Cars In The Past...
Asked by notapromike
Transmission Control Module
The Codes Showed That The Control Module Had Gone Out, Along With Air Lock In Gas Tank, And O2 Sensor. I Replaced The Control Module With A...
Asked by Fieldlily
Rear-end Noise
My 1996 Chrysler Cirrus Lx Is Making A Grinding Noise In The Rear End, Especially Around Turns. It Now Is Grinding All The Time, But Gets...
Asked by BSharp
Transmission Problem
Hi, My Chrysler Town And Country Is Stuck In What I Think Is 3rd Gear. A Friend Said His Mechanic A Capful Of Brake Fluid In The Tranny May...
Asked by rlc64
Auto Reoair
I Have A ’96 Chrysler Lhs W/ Abs. The Half Shaft Went Bad And I Am Trying To Replace It. I Cannot Get The Old Shaft Out. Everyone Tells Me...
Asked by KeWalt
Transmission
1996 Chrysler Sebring Convertible, 3.0v6 Auto Trans
Cold Weather All Is Well. In Warm Weather The Transmission Goes Into Limp Mode After...
Asked by bill217
1996 Chrysler LHS
Transmission Problem
1996 Chrysler Lhs 6 Cyl Automatic
Every Time I Drive My Car It Drives Good But Some Times It Dont Want To Change...
Asked by kathy09
Browse other repair topics
Can’t find your issue?
Ask a new Chrysler question
