Chevrolet S-10 Engine

Browse Chevrolet S-10 Engine questions and answers. Choose a question that matches your symptoms.

2,116 discussions


Will Not Start After Draining The Battery

1987 CHEVROLET S-10
Drove My Truck To The Store Left The Lights On When I Came Back Out The Battery Was Dead. So I Took The Battery Home And Charged It. When I...
4 ANSWERS
1 IMAGE
Asked by Leon Allen

Check Oil Pump

1987 CHEVROLET S-10
No Oil Pressure. How Can I Check Oil Pump Without Removing Pan?
1 ANSWER
Asked by gaylandmatz

Starter Makes A Bad Noise Sound Like The Starter...

1987 CHEVROLET S-10
When Turn The Key To Cranking The The Starter Makes A Bad Noise Sound Like The Starter Bendix Not Engaging Into The Fly Wheel. But When I...
6 ANSWERS
Asked by joe1953

Will Not Start

1987 CHEVROLET S-10
The Truck Died On Me While Driving Just Like The Ignition Was Switched Off, But All The Indicator Lights Were Still On. It Will Crank, But...
1 ANSWER
Asked by THOMAS MCCULLEY

Crank No Start?

1987 CHEVROLET S-10
Have Replaced Fuel Pump, Relay And Pcm. I Have Spark But Fuel Pump Does Not Cycle When Key Is Turned On
4 ANSWERS
1 IMAGE
Asked by rudedog68

1987 Chevrolet S-10 Crank, No Start

1987 CHEVROLET S-10
I Have Replaced Fuel Pump, Relay And The Pcm. I Have Spark And The Engine Turns Normally, It Has A Very Recent Engine Rebuild And Ran Fine...
2 ANSWERS
1 IMAGE
Asked by rudedog68

V8 In S10

1987 CHEVROLET S-10
Just Wondering How Much Work And What Ive Got To Do To Go From A 2.5 Four Cylinder To A 355 Chevy V8 I Would Really Like To Have Alot Of...
1 ANSWER
Asked by john pace 56

Truck Wont Run Unless You Unplug The Map Sensor

1987 CHEVROLET S-10
Truck Wont Run Unless You Unplug The Map Sensor
1 ANSWER
Asked by Anonymous

Where Are The Bolts That Hold The Starter For 1987...

1987 CHEVROLET S-10
I've Removed One Long Bolt And One Short Bolt That Was Holding A Shim. The Starter Is Loose, But I Don't See Any Other Bolts That Are...
2 ANSWERS
Asked by fohnjaubion

Could A Faulty MAP Sensor Cause An Engine To Blow...

1987 CHEVROLET S-10
Replaced Head, Push Rods, And Water Pump Running Good For 2 Weeks, Still A Little Rough At Cold Starts. Just Started To Blow Smoke At Idle...
3 ANSWERS
Asked by wmika@frontiernet.net

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCrankshaftCylinder HeadTickDrain PlugFlexplateFlywheelHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CoolerOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterThrottle BodyTiming BeltTiming ChainTune-upVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Chevrolet S-10 question