VSS location

2003 JEEP LIBERTY
141,000 MILES • 3.7L • 6 CYL • 4WD • AUTOMATIC
Avatar
DAVE390
  • MEMBER
  • 2 POSTS
I have replaced two s sensors one should have been the output and one should have been input, but I still have an engine light on P0500 code. could this be and the transmission control module?
Feb 19, 2018 at 12:21 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
Good afternoon.

Do you have ABS with your truck?

Roy
Feb 19, 2018 at 12:52 PM
Advertisement
Avatar
DAVE390
  • MEMBER
  • 2 POSTS
Yes.
Feb 19, 2018 at 1:17 PM
Avatar
ASEMASTER6371
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 52,796 POSTS
Okay, the vehicle speed sensor that sends a signal to the PCM is the ABS sensor on the rear differential. it uses the ABS signal for a sign of vehicle speed.

Check the connector for any damage or spread pins.

Roy
Feb 19, 2018 at 1:20 PM