Shifted the transmission into drive it would not go?

2013 FORD ESCAPE
180,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
C.CLAXTON8691
  • MEMBER
  • 4 POSTS
I have the vehicle listed above that shut off on me at a stop light. I restarted the car and when I put the car in drive it wouldn't go. I got the car parked and put it in reverse and it would go in reverse and then it started to go in drive but now it won't pull. Transmission not in park also showed on the dash. Any ideas on what's wrong with it?
Apr 1, 2025 at 11:40 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,180 POSTS
Yes, can I ask if the other gears show up in on the dash when selected? If not, I have seen the gear range sensor go out and cause this issue, here are the locations so and can swap it out. Also, we should run the codes to see if any are stored.

https://www.2carpros.com/articles/checking-a-service-engine-soon-or-check-engine-light-on-or-flashing

If you can please upload a short video of the problem so I can see which can help as well. Check out the images (below). Please let us know what happens.

Images (Click to enlarge)
Attached Media
Attached Media
Apr 1, 2025 at 6:33 PM
Advertisement