Transmission replacement I'm about 3/4 of an inch away from getting it in

Tiny
RYAN SULLIVAN
  • MEMBER
  • 1995 FORD RANGER
  • 3.0L
  • 6 CYL
  • 2WD
  • MANUAL
  • 200,000 MILES
I dropped the transmission to replace the clutch slave cylinder and throw-out bearing. Now that I'm putting the transmission back in place I'm about 3/4 of an inch away from getting it in it's lined with the spline and the clutch pad.
Wednesday, July 31st, 2019 AT 10:57 AM

1 Reply

Tiny
KASEKENNY
  • MECHANIC
  • 18,907 POSTS
Hi Ryan,

Are you using the clutch alignment tool? If not, the disc is getting hung up on the input shaft. I know you said it is inline but if you are not using that tool then it may just look like it is lined up but if they are just a fraction off, then it will get hung up right where you are getting to.

https://www.2carpros.com/articles/how-to-replace-a-clutch
Was this
answer
helpful?
Yes
No
Tuesday, May 4th, 2021 AT 10:54 AM

Please login or register to post a reply.

Sponsored links