Transmission output shaft seal replacement?

2009 TOYOTA SIENNA
170,000 MILES • 3.5L • 6 CYL • 2WD • AUTOMATIC
Avatar
JASON SPAGNOLIA
  • MEMBER
  • 1 POST
I’m replacing the output shaft seal while replacing the CV axle. There is a spring in the seal, and I need to know does the side the spring is on go inside the transmission or face out (towards the wheel)?
Jun 12, 2023 at 11:05 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
Hi,

The spring should face inward toward the transmission. Make sure to lubricate the new seal with transmission fluid prior to installing the new axle.

Let me know if you have questions.

Take care,

Joe
Jun 12, 2023 at 10:00 PM
Advertisement