1999 Toyota Tacoma location for two plugs??????? under hood

1999 TOYOTA TACOMA
Avatar
ROB559
  • MEMBER
  • 2 POSTS
Electrical problem
1999 Toyota Tacoma 6 cyl Four Wheel Drive Manual

cannot find the location for these two or single plugs unknown if they went together cause they were pinched under the intake and the plastic plugs on ends were damaged and broken off completely.
after work done by another person that couldnt get it started after changing head gaskets.

then i get the truck, and see these pinched and bolted down under the intake manifold.
my question is. what is the correct place these plugs go.
the car wont crank over you can just here the starter relay click.

they are a gray plug with black, gray, brown wire that are spliced to a solid blue and blue/orange stripe.
these are coming off the injector harness. and all the injectors are plugged in. i cant find any spot for these two wires. help![img:ac6d0055fe]http://www.2carpros.com/forum/automotive_pictures/494243_SDC11677_1.jpg[/img:ac6d0055fe]
Mar 4, 2010 at 3:28 PM
Advertisement
Avatar
DOCFIXIT
  • ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Hi
Best advise I can give is find another vehicle and look to see where they go.
Mar 8, 2010 at 1:02 PM
Avatar
ROB559
  • MEMBER
  • 2 POSTS
thnx for nothing enjoy the $3
Mar 8, 2010 at 11:43 PM
Avatar
DOCFIXIT
  • ASE Certified Mechanic
  • 18,828 POSTS
  • ASE Certified Mechanic
Really doubt those wires are the cause of not cranking. Make sure battery is 12.6 volts or higher.Terminals tight at batt and starter.
Mar 9, 2010 at 9:46 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.