No spark

TOYOTA PASEO
Avatar
ALEMAN33
  • MEMBER
  • 2 POSTS
I have a 1993 Toyota Paseo and I can’t get any spark. I replaced/installed the following: brand new distributor (including cap, rotor, coil), sparks plugs, wires, igniter, EFI relay. I check voltage on coil and it was good. I even cranked the engine while checking coil voltage and it was good. The car was parked for about two years. I try to retrieve computer code, but I didn’t get any. Any advice or ideas will be greatly appreciated.
Mar 17, 2007 at 5:09 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 75,992 POSTS
[quote:3c61221b41="aleman33"]I have a 1993 Toyota Paseo and I can’t get any spark. I replaced/installed the following: brand new distributor (including cap, rotor, coil), sparks plugs, wires, igniter, EFI relay. I check voltage on coil and it was good. I even cranked the engine while checking coil voltage and it was good. The car was parked for about two years. I try to retrieve computer code, but I didn’t get any. Any advice or ideas will be greatly appreciated.[/quote:3c61221b41]

What voltage? the power input to the coil or the center of the coil.

Check the Ignition and EFI fuse
Mar 18, 2007 at 8:43 AM
Advertisement
Avatar
ALEMAN33
  • MEMBER
  • 2 POSTS
It's fixed. I replaced the computer and it started like a champ. thank you for your help.
Mar 22, 2007 at 11:48 AM