1985 Toyota Corolla Valve clearance

1985 TOYOTA COROLLA
200,000 MILES • 4 CYL • FWD • AUTOMATIC
Avatar
PETERDI
  • MEMBER
  • 2 POSTS
What should be the valve clearance for this model toyota Corrola?
Thanks to Mark for answering my previous post, VERY much appreciated.
kind regards to all.
P.F
Nov 11, 2008 at 2:02 AM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Hi there,

carby engine, inlet .20mm exh .30mm
EFI engine inlet .20mm exh .25mm

Both engines should be at normal operating temp to set clearances.

mark (mhpautos)
Nov 11, 2008 at 2:49 AM
Avatar
PETERDI
  • MEMBER
  • 2 POSTS
Thank you Mark, your help is greatly appreciated.
Kind regards.
Peter
Nov 11, 2008 at 3:19 AM
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Good luck and i hope the re build goes well, thank you for using 2carpros.

Mark (mhpautos)
Nov 11, 2008 at 3:26 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.