Check gauges light on, scan tool says PCM not exist, will not start?

2007 DODGE TRUCK

242,160 MILES • 6.7L • V12 • TURBO • 2WD • AUTOMATIC

BRIAN GIBSON

MEMBER
1 POST
FOLLOW

Motor swap 2 months ago, the truck has run fine, stopped got fuel today drove 20 minutes stopped to eat. Came out truck cranks but no start. Check gauges light on. Scan tool says PCM not exist. No power to fuel pump. Changed the CPS, fuel pump relay, exhaust pressure sensor. Checked the grounds I could find. Unhooked the batteries. Still stranded beside the road. Any help will be greatly appreciated.

Oct 19, 2024 at 10:29 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

STRAILER

AUTOMOTIVE REPAIR CONTRIBUTOR
54,178 POSTS

I would recheck the ground connection of the PCM to the engine. Then, check all of the fuses, this guide can help:

https://www.2carpros.com/articles/how-to-check-a-car-fuse

If all fuses are okay let's check for power and ground at the PCM, you may have a TIPM that has gone out which is common, here is a guide to help and I have included the PCM wiring diagrams so you can see which wires to test for power and ground. Here are the fuse locations as well. They don't list a 6.7-liter v12 engine turbo?

https://www.2carpros.com/articles/how-to-use-a-test-light-circuit-tester

Test the fuses with the key on. Check out the images (below). Please let us know what happens.

Images (Click to enlarge)

Oct 20, 2024 at 12:15 PM