Stalling while in idle and at intersections?

2007 CHRYSLER 300
244,000 MILES • 2.7L • 6 CYL • 2WD • AUTOMATIC
Avatar
HERE IN MY CAR
  • MEMBER
  • 1 POST
Had heads replaced. Stalling while in idle and at lighted intersections place in park starts right up. (No check engine light at all)

Replaced, crank sensor, cam sensor, throttle body (and its connection on wiring harness) MAF sensor, MAP sensor, oil pressure sensor, and coolant temperature sensor...

Still stalling! No check engine light, still running on oil shop put in after repairs. Not synthetic (What I've always used in car since I've had it)

Suggestions much appreciated!!
Jan 5, 2023 at 12:35 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,178 POSTS
It sounds like you have a vacuum leak, or the air intake tube is loose or cracked. here is a guide to help is fix it, please follow this guide when the engine is cold only:

https://www.2carpros.com/articles/how-to-use-an-engine-vacuum-gauge

This guide can help as well:

https://www.2carpros.com/articles/stall-at-idle

Can you please shoot a quick video with your phone so I can see the engine run and stall? That way I can tell for sure what's going on. You can upload it here with your response.




Jan 5, 2023 at 11:49 AM
Advertisement