wiring harness diagram

2003 FORD F-150

228,000 MILES • 4.6L • V8 • 2WD • AUTOMATIC

RCOLE0388

MEMBER
1 POST
FOLLOW

I just put a 4r70w transmission out of salvage yard in and when I drove it after install my speedometer goes an hits a 100 mph and I am only doing about 30. I believe it is tripping the governor because it shuts down until needle drops below 99 mph. I have replaced speed sensor in differential and rear of transmission. it never did this with old transmission.

Sep 8, 2017 at 7:32 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

STRAILER

AUTOMOTIVE REPAIR CONTRIBUTOR
54,178 POSTS

Did you have the 4r100 before? I would check the connection at the output shaft speed sensor. Here are the wiring diagrams (below) for both so you can do a pin to pin check by following this guide.

https://www.2carpros.com/articles/how-to-check-wiring

Please let us know what happens and upload pictures of the problem.

Cheers, Ken

Images (Click to enlarge)

Sep 9, 2017 at 11:46 AM